English Manual
English 3
2.Place one or two hard driver(s) in the slot. Make sure the SATA connector is lined up with the connector inside the Mobile Rack.
3.Carefully push the hard driver into the Mobile Rack, So that the drive’s SATA connector is seated securely, then close the doorr and lock it.
Note: It must be in the lock position when in use. This prevents unexpected removal while working.
Note:
1.Users are advised to disable the device from the computerr before unplugging the cable or turning offf the device.
2.If the hard drive does not support ACCESS signal, then the HDD ACTIVE LED will not flash when the hard drive is in use.
3.If the system cannot detect the device, please go to device management and enable it.
4.Do not open the d oor or turn off the power of the Mobile Raack while the hard drive is busy, this may c ause damage to you hard drive.
5.It must be in the lock position when in use. This preventts unexpected removal while working.
6.Do not force the door to open while it is locked, otherwisee, you will damage the lock.
RAID Inform ation：
Caution: Changging the RAID mode destroys data stored on the Mobile Rack, If you have saved data on the drives, back up data before foollowing these steps.
1.JBOD
single housing, so that two logical volu mes mount on the desktop. Therefore, the computer will s how two separate drives.
Note: When using the
The failure of one disk will not affect the other disk. Therefore, the data on the working drivve will be intact and functioning.
2. | BIG (Concatenation): The two physical drives are combined |
| so that one single |
| yet larger logical volume mounts on th e desktop, offerining |
maximum possible capacity (the availaable capacities of each disk are combined).
Note: If one physical disk fails, the data on both disks will become inaccessible. If you are concerned about
