Line 6 headphones powered monitors manual GuitarPort Connections

Line 6 GearBox 3.1 – Basic Features Guide

GuitarPort Connections

Instrument input - your electric guitar or bass, plug it into one of these inputs using a standard 1/4-inch TS instrument cable. This inputs the signal into GearBox where you can choose your Tone and route the processed signal both to your audio software and out the GuitarPort outputs.

Analog Line Outs – connect to	Connect your stereo
your powered speakers or mixer	headphones

Connect USB cable from

Monitor In – connect a line level, stereohere to your computer output (from your stereo, MP3 player, etc).

Analog Line Outs - These Left and Right RCA jacks output all audio signals; the audio from your audio software on the computer, and anything plugged into any the Instrument or Monitor inputs. So, these are what you want to connect to your monitoring system when using GuitarPort as your computer’s sound card. Use sheilded RCA to RCA tipped cables to connect directly to your powered speakers, mixer or power amp setup. Note that you can also use the headphone jack on GuitarPort if you want to use headphones for monitoring.

Headphones - If you want to listen to the audio using stereo headphones, then plug them into this 1/8- inch stereo jack. This Headphone jack outputs the same signal fed to the Analog Line Outs; the audio from your audio software on the computer, as well as anything plugged into the Instrument or Line inputs.

Monitor In - If you want to hear the signal from a line level source mixed with all the other audio coming from your computer, but do not want this audio recorded, then plug the source in here. Note that this is a stereo jack, so you should use a stereo 1/8-inch tipped stereo audio cable for this connection. You’ll hear any audio coming into this jack via the Analog Line Outs and Phones, but it won’t go to GuitarPort’s Record Send 1-2.

Page 36