Linear AM-KPI installation instructions Introduction, Keypad Features, Open The Keypad, Am-Kpi

	1. INTRODUCTION		2. KEYPAD FEATURES
	The Model AM-KPI keypad is designed for use with Linear’s AM/II		RED/GREEN	YELLOW
AM-KPI	access control system. The keypad is housed in a rugged, plastic
			POWER/ACCESS	"LOCKOUT"
	enclosure and is designed to be mounted indoors in a standard single-
			INDICATOR	INDICATOR
	gang electrical box. Tamper resistant screws secure the keypad to its
	mounting plate. The die-cast keys have bright, easy-to-read yellow
Access	graphics.		BEZEL
	The keypad is supplied with a satin-chrome plastic bezel installed.
Control	Three interchangeable colored plastic bezels (white, ivory, & bronze)			SOLID STATE
	are included with the unit to customize the keypad appearance for the
				WHITE LED
Keypad	installation.			DOWN LIGHT	DEVICE
	All system indicators and lights are long-lasting, solid-state LEDs. Two				ADDRESS
	indicators show the status of the entry system. The left indicator lights				SELECTOR
	red to indicate power, then turns green when access is granted. The		FACEPLATE
Installation	right indicator lights yellow when the keypad is in “lockout” condition		KEYPAD
	(from too many incorrect code entries). A white LED downlight lights
Instructions	the keypad for nighttime use. An internal sounder beeps when each
	key is pressed.
	The AM-KPI is normally powered from the AM/II controller. Alternately,
	the keypad can be powered locally with a 12 VDC power supply.		TERMINAL
	Robust static and lightning protection circuits safeguard the keypad’s
			BLOCK
	electronics.
	A rotary switch selects the keypad’s device address. Each device
	connected to the AM/II must be set to a different device address.		MOUNTING
(760) 438-7000 • FAX (760) 438-7043			PLATE
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
www.linearcorp.com
3. OPEN THE KEYPAD	4. CUSTOMIZE THE BEZEL (OPTIONAL)		5. INSTALL WALL BOX & MOUNTING PLATE
1 PRY UP ON THE	TO CHANGE THE APPEARANCE OF THE KEYPAD
FACEPLATE HERE				INSTALL A SINGLE-GANG
	TO BLEND IN WITH THE INSTALLATION,
	CHOOSE THE APPROPRIATE KEYPAD BEZEL			ELECTRICAL BOX AT THE
				PROPER LOCATION
2 REMOVE THE	KEYPAD BEZEL COLORS:			FOR THE KEYPAD
FACEPLATE
	• SATIN-CHROME (FACTORY INSTALLED)	KEYPAD
	• WHITE
	• IVORY	BEZEL
	• BRONZE
	KEYPAD
	ASSEMBLY
				MAKE SURE THE
				TAB IS UP
MOUNTING
PLATE
3 REMOVE THE	THE BEZEL SNAPS		ATTACH THE MOUNTING	MOUNTING
TWO SCREWS	ONTO THE KEYPAD		PLATE TO THE	PLATE
	ASSEMBLY		ELECTRICAL BOX
4 SEPARATE THE
MOUNTING PLATE
FROM THE KEYPAD