Route The Cable, Connect The Cable & Set The Device Address

ROUTE THE CABLE

7. CONNECT THE CABLE & SET THE DEVICE ADDRESS

8. MOUNT THE KEYPAD

EACH AM-KPI KEYPAD EQUALS 9 LOAD UNITS

FOLLOW THIS WIRING DIAGRAM

1 HOOK THE KEYPAD ASSEMBLY

CABLE LENGTH FORMULA FOR EACH KEYPAD USED IN THE SYSTEM

TO CONNECT THE KEYPAD

ONTO THE MOUNTING PLATE

TO THE AM/II CONTROL

1 O

1 B

KEYPAD IN

1 B

INSTALL THE

TWO SCREWS

CABLE RUN

CABLE TYPE

FORMULA

300 FEET MAXIMUM

BELDEN 9931 (24 AWG)

FEET x LOAD UNITS < 3,000 MAXIMUM

500 FEET MAXIMUM

WEICO 9405 (20 AWG)

FEET x LOAD UNITS < 10,000 MAXIMUM

SET THE DEVICE

GRN

BLK

WHT

BLU

ORG/YEL

RED

ADDRESS SWITCH

EACH REMOTE DEVICE

MUST BE SET TO A

UNIQUE NUMBER

FROM 1 TO 6

HOMERUN WIRE FROM THE AM/II

TO EACH KEYPAD'S LOCATION

(1000 FEET WIRE MAXIMUM

PCLK DVAL DAT0 DAT1 GND

PWR

ALLOWED IN THE SYSTEM)

CAUTION

FIT THE BOTTOM TAB OF

TO PROTECT THE KEYPAD FROM

THE FACEPLATE INTO THE

STATIC DISCHARGES, BE SURE

SLOT ON THE KEYPAD

EARTH GROUND IS CONNECTED

ARROW ON SWITCH SLOT

TO THE AM/II CONTROL

POINTS TO THE NUMBER

SNAP THE TOP

FOR LOCAL POWER, DISCONNECT RED WIRE FROM "PWR" CONNECTION ON AM-KPI

OF THE KEYPAD

INTO PLACE

AND CONNECT EXTERNAL 12 VDC POWER SUPPLY (+ TO PWR & - TO GND)

NOTE: AM/II

MUST STILL BE CONNECTED TO AM-KPI "GND"

PROGRAM THE SYSTEM

10. TEST THE KEYPAD

LINEAR LIMITED WARRANTY

1 THE RED INDICATOR

This Linear product is warranted against defects in material and workmanship for twenty-

PROGRAM THE AM/II

four (24) months. The Warranty Expiration Date is labeled on the product. This warranty

extends only to wholesale customers who buy direct from Linear or through Linear’s normal

TO CONFIGURE THE KEYPAD(S)

SHOULD BE LIT

distribution channels. Linear does not warrant this product to consumers. Consumers should

AND SET THE ENTRY CODES

inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no

2 ENTER A VALID CODE

obligations or liabilities on the part of Linear Corporation for consequential damages arising out of or

in connection with use or performance of this product or other indirect damages with respect to loss of

REFER TO THE AM/II

3 THE RED INDICATOR SHOULD TURN

property, revenue, or proﬁt, or cost of removal, installation, or reinstallation. All implied warranties,

PROGRAMMING INSTRUCTIONS

including implied warranties for merchantability and implied warranties for ﬁtness, are valid

only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is

FOR DETAILS

GREEN AND THE PROGRAMMED

in lieu of all other warranties express or implied.

RELAY IN THE AM/II SHOULD ACTIVATE

All products returned for warranty service require a Return Product Authorization Number

(RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other

important details.

FCC NOTICE

Changes or modiﬁcations not expressly described in this manual or approved by the

manufacturer could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

THE YELLOW INDICATOR LIGHTS WHEN

THE KEYPAD IS LOCKED OUT OR BUSY

218940 A

Linear AM-KPI Route The Cable, Connect The Cable & Set The Device Address, Mount The Keypad

Models: AM-KPI