Front Panel LEDs | Linksys PAP2-NA specs

Phone Adapter with 2 Ports for Voice-over-IP

Front Panel LEDs

The Phone Adapter’s LEDs are located on the front panel.

	Figure 2-2: Front Panel
PHONE 1 LED	Blue. The PHONE 1 LED is solidly lit when a telephone or fax machine has a registered
	connection to your Internet phone service provider through the PHONE 1 port. (The connection
	is registered if your Internet phone service account is active.) This LED is not lit when there is
	no registered connection. It flashes when the phone is being used or an incoming call has
	been detected.
PHONE 2 LED	Blue. The PHONE 2 LED is solidly lit when a telephone or fax machine has a registered
	connection to your Internet phone service provider through the PHONE 2 port. (The connection
	is registered if your Internet phone service account is active.) This LED is not lit when there is
	no registered connection. It flashes when the phone is being used or an incoming call has
	been detected.
ETHERNET LED	Blue. The ETHERNET LED lights up when the Phone Adapter is connected to your network
	through the Ethernet port. It flashes when there is data being sent or received through the
	Ethernet port.
Power LED	Blue/Red. The Power LED lights up when the Phone Adapter is powered on and ready. It
	flashes when the Phone Adapter is booting up, undergoing a self-test, or performing a
	firmware upgrade.
	The LED lights up red when the Phone Adapter has failed its self-test or is malfunctioning.
	Refer to “Appendix A: Troubleshooting” for more information.

Chapter 2: Getting to Know the Phone Adapter

4

Front Panel LEDs

Image 8

Linksys PAP2-NA manual Front Panel LEDs

Contents

Phone Adapter How to Use this Guide Copyright and Trademarks Table of Contents Back Panel Front Panel What’s in this Guide? IntroductionWelcome Introduction What’s in this Guide? Getting to Know the Phone Adapter Back Panel Ports Front Panel LEDs Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview Router Phone Adapter Connect the Ethernet Network Cable Placement Options Stand OptionWall-Mount Option Remove the plate from the Phone Adapter’s bottom panel Using the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuAccessing the Interactive Voice Response Menu Has been enabled or disabled. If Interactive Voice Response Menu 121 Enter the network 7932 Enter 1 to enable This feature is protected by a Entering a Password Configuring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and Solutions Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to IP address Phone Adapter Internet phone 69 to IP address Phone Adapter Internet phone 69 to Frequently Asked Questions Ethernet LED does not light up Network Neighborhood/My Network Places Appendix B Windows HelpShared Resources Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Temp Operating HumidityStorage Humidity 10~90% Non-Condensing Appendix E Warranty Information Limited Warranty Appendix F Regulatory Information This product complies with Canadian ICES-003 Appendix G Contact Information Linksys