
EtherFast®10/100 Bridge and USBAdapter
27
Instant PowerLineTM Series
26
2. All of the Instant PowerLine devices on your powerline network must share
the same network password. The password must have between 4 and 24
characters. The password is case-sensitive, so note whether you use lower-
case or uppercase letters. The password can include any letters of the alpha-
bet, numbers, or punctuation marks. Type in your password in the Network
Passwordfield. Then click the Next button.
Figure 10-2
Important:Remember this password. You will need to set this pass-
word on each Instant PowerLine device on your powerline network.
Chapter 10: Using the SecurityConfiguration UtilityAfter installing your EtherFast 10/100 Bridge or USBAdapter and USB driv-
er, you will run the Security Configuration Utility for each Instant PowerLine
device. This utility will set up security using a network password.
To ensure the security of an Instant PowerLine Device, set up a
network password using the Instant PowerLine Security
Configuration Utility. To begin, double-click the Security
Configuration Utility icon on your desktop.
1. You will see the screen shown in Figure 10-1. Click the Nextbutton.
Note: Make sure your TCP/IP protocol is set up appropriately on
your computer before running the Security Configuration Utility.
For more information, refer to Appendix C:IP Addressing.
Overview
Setting Up Security on an Instant PowerLine Device
Figure 10-1