Linksys RV042 manual Tunnel No The tunnel number is automatically generated

Chapter 4 Advanced Configuration

VPN > Client to Gateway

NOTE: The 10/100 4-Port VPN Router supports IPSec VPN client software, including the Linksys QuickVPN software.

To manage access for Linksys QuickVPN clients, click the VPN Client Access tab. (For more information about QuickVPN, refer to “Appendix B: Linksys QuickVPN for Windows 2000, XP, or Vista”.)

Add a New Tunnel

Tunnel/Group VPN  To create a tunnel for a single VPN client, select Tunnel. To create a tunnel for multiple VPN clients, select GroupVPN.The GroupVPN feature facilitates setup and is not needed to individually configure remote VPN clients.

Depending on your selection, the Local Group Setup and Remote Client Setup settings will differ. Proceed to the appropriate instructions for your selection.

Tunnel

Tunnel No  The tunnel number is automatically generated.

Tunnel Name  Enter a name for this VPN tunnel, such as Los Angeles Office, Chicago Branch, or New York Division.

This allows you to identify multiple tunnels and does not have to match the name used at the other end of the tunnel.

Interface  Select the appropriate WAN port, WAN1 or WAN2 (available if the Dual WAN feature is enabled).

Enable  Check this box to enable a VPN tunnel.

Local Group Setup

Local Security Gateway Type

Select the type you want to use: IP Only, IP + Domain Name(FQDN) Authentication, IP + E-mail Addr.(USER FQDN) Authentication, Dynamic IP + Domain Name(FQDN) Authentication, or Dynamic IP + E- mail Addr.(USER FQDN) Authentication. Follow the instructions for the type you want to use.

NOTE: The Local Security Gateway Type you select should match the Remote Security Gateway Type selected on the VPN device at the other end of the tunnel.

IP Only

The default is IP Only. Only the device with a specific IP address will be able to access the tunnel.

Local Security Gateway Type > IP Only

IP address  The WAN (or Internet) IP address of the Router automatically appears.

IP + Domain Name(FQDN) Authentication

The IP address and FQDN must match the Remote Security Gateway of the remote VPN device, and they can only be used for one tunnel connection.

Local Security Gateway Type > IP + Domain Name(FQDN)

Authentication

Domain Name  Enter the Fully Qualified Domain Name (FQDN), which is the host name and domain name for a specific computer on the Internet.

IP address  The WAN (or Internet) IP address of the Router automatically appears.

10/100 4-Port VPN Router 41