10/100
Dead Peer Detection (DPD): When DPD is enabled, the RV082 will send the periodic HELLO/ACK messages to prove the tunnel liveliness when both peers of VPN tunnel provide DPD mechanism. Once a dead peer has detected, the RV082 will disconnect the tunnel so the connection can be
The Interval is the number of seconds between DPD messages. The default is DPD enabled, and default Interval is 10 seconds.
Click the Save Settings button when you finish the settings or click the Cancel Changes button to undo the changes.
VPN Tab - VPN Client Access
Use this page to administer your VPN Client users. Enter the information at the top of the screen and the users you’ve entered will appear in the list at the bottom, showing their status. This will work with the Linksys QuickVPN client only. (The Router supports up to five Linksys QuickVPN Clients by default. Additional QuickVPN Client licenses can be purchased separately. See www.linksys.com for more information.)
Username: Enter the user’s name here.
New Password: Enter the user’s password here.
Confirm New Password: Confirm that password by
Change Password Allowed: If you want to allow users the right to change their password, click the radio button beside Yes. If not, click the radio button beside No.
Active: Clicking this box will make the new user active.
Add to List: Clicking this button adds the user to the list at the bottom of the screen.
All of these settings can be changed by clicking the user’s name in the box at the bottom half of the screen. The Add to List button changes to Update this user. Click the Update this user button to change the user’s settings.
Delete selected users: You can delete users by clicking their name(s) in the list and then clicking the Delete selected users button. Hold down the CTRL key when selecting multiple users.
Add New: Clicking this button also allows you to add new users to the VPN Client Access list.
Click the Save Settings button to save the settings or the Cancel Changes button to undo your changes.
When you first save these settings, a message will appear, asking if you’d like the Router to automatically change the LAN IP Address to prevent conflicting IP addresses. Clicking Yes will change the LAN IP Address. In the event of an IP conflict, the VPN Client will not connect to the Router.
Chapter 5: Setting Up and Configuring the Router
Figure
54
VPN Tab - VPN Client Access
