Linksys WAP51AB manual Instant Wireless Series

Instant Wireless™ Series

11.The following Security screen, shown in Figure 5-7, will allow you to enter your WEP key. Each point in your wireless network must use the same WEP key for the network to function properly. Verify that the appropriate key is entered and click the Next button to continue or Back to return to the pre- vious page.

The WEP key can consist of the letters “A” through “F” and the numbers “0” through “9” and should be 10 characters in length for 64-bit encryption or 26 characters in length for 128-bit encryption. All points in your wireless network must use the same WEP key to utilize WEP encryption.

Figure 5-10

12.You should now review the settings you’ve chosen, as shown in Figure 5- 11. If these settings are correct, click the Yes button to save these settings. If you wish to change any of the settings, click the No button. You will exit the Setup Wizard and can start it again to revise your settings.

Dual-Band Wireless Access Point

Figure 5-11

13.At this point, the configuration performed with the Setup Wizard is com- plete, as shown in Figure 5-12. To configure any other Access Points in your network, you can run this Setup Wizard again. Click the Exit button to exit the Setup Wizard.

Figure 5-12

14 15