UK Users Please Read This
Important Safety Information
Fuse replacement
This appliance is fitted with a
a)Pull out the red fuse cover/carrier.
b)Remove and dispose of the blown fuse.
c)Fit a new 5 amp BS1362 approved fuse into the carrier and push the carrier back into the plug.
Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the plug. Contact your Linn retailer to obtain a replacement fuse cover.
Fuses are for fire protection and do not protect against electric shock.
Mains plug replacement
Should your mains plug need replacing and you are competent to do this proceed as follows. If you are in doubt contact your Linn retailer or a competent electrician.
a)Disconnect the plug from the mains supply.
b)Cut off the plug and dispose of it safely. A plug with bared conductors is dangerous if engaged in a live socket.
c)Only fit a 13 amp BS1363A approved plug with a 5 amp fuse.
d)The cable wire colours or a letter will be marked at the connection points of most quality plugs.
Attach the wires securely to their respective points. The Brown wire must go to the Live pin, the Blue wire must go to the Neutral pin, and the Green/Yellow wire must go to the Earth pin.
e)Before replacing the plug top ensure that the cable restraint is holding the outer sheath of the cable firmly and that the wires are correctly connected.
WARNING
THIS APPLIANCE MUST BE EARTHED.
CE Declaration of Conformity
Linn Products Ltd declare that this product is in conformance with the Low Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC as amended by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive number 73/23/EEC (LVD) is proved by full compliance with the following standards:
Standard number | Date of issue | Test type |
|
EN60065 | 2002 | General requirements |
|
|
| Marking |
|
|
| Hazardous radiation |
|
|
| Heating under normal conditions |
|
|
| Shock hazards under normal |
|
|
| operating conditions |
|
|
| Insulation requirements |
|
|
| Fault conditions |
|
|
| Mechanical strength | iii |
|
| Parts connected to the mains |
|
|
| supply |
|
|
| Components |
|
|
| Terminal devices |
|
|
| External flexible cords |
|
|
| Electrical connections and |
|
|
| mechanical fixings |
|
|
| Protection against electric shock |
|
|
| Stability and mechanical hazards |
|
|
| Resistance to fire |
|
The conformity of the designated product with the provisions of Directive |
| ||
number 89/336/EEC (EMC) is proved by full compliance with the following |
| ||
standards: |
|
|
|
Standard number | Date of issue | Test type |
|
EN55013 | 2001 | Conducted emissions |
|
EN55013 | 2001 | Absorbed emissions |
|
EN55020 | 2002 | Immunity |
|
AKURATE DS
