CR100 Universal remote control | ||
The CR100 is a ‘universal’ remote that controls the AVR350 and up to |
| |
Device selection | ||
seven other devices. The instructions on this page only refer to the | ||
IMPORTANT: Press the ‘AMP’ button first to | ||
control of the Arcam AVR350. | ||
operate the AVR350. | ||
For information on using the remote control for other devices, and a | ||
| ||
full list of its features, see the Handbook supplied with the CR100. |
|
English
This allows the AVR350 to be put into and taken out of
If you do not wish to put Zone 2 into
TAPE
Selects Tape input for the amplifier
Navigation buttons
Arrow buttons allow navigation around the Basic and Advanced
Confirm a selection by pressing OK.
ShifT B to Power on
Shift C to Power off
Shift E to switch Zone 2 on
Shift D to switch Zone 2 off.
MODE
Cycles through available audio surround modes.
MUTE
Press once to mute the main system. Press again (or use VOL
VOLUME +/–
Adjusts the sound output.
These buttons are described on the next page.
� | � |
| � |
� | � |
| � |
� | � |
| � |
|
|
| �� |
���� | � | ������� | ��� |
|
|
| �� |
����� | ��� | ��� | |
��� | ��� | �� | ��� |
|
| ||
��� | ��� | ��� | �� |
���� |
|
| ���� |
|
| ���� |
|
|
|
| �� |
������ | �� | ��� | �� |
��� | ���� | ��� | ���� |
|
|
| ���� |
������� | ������ | ����� | ���� |
����� | ����� | ����� | ���� |
Source selection only
1 | DVD input |
2 | CD player input |
3 | Television (sound) input |
4 | Auxiliary (line) input |
5 | Video Cassette Recorder input |
6 | Satellite decoder input |
7 | DAB/FM/AM tuner input |
Press the relevant button once to select input.
Source selection and handset configuration
DVD | DVD input/DVD commands |
SAT | Satellite decoder input/SAT commands |
av | Television (sound) input/AV commands |
tun | Radio tuner input/TUN commands |
amp | Amplifier. Press first to operate the AVR350 |
aux | Auxiliary (line) input/AUX commands |
vcr | Video Cassette Recorder input/VCR |
| commands |
cD | CD player input/CD commands |
Press the relevant button once to select input and reconfigure the handset. Press and hold to select the input without reconfiguring the remote.
MENU
Press to select the OSD Main menu.
Press and hold for more than three seconds to select the
DISP (Display)
Press to cycle through Off/Dim/Bright illumination of the front panel display
0 /
If the tuner is in Preset mode, these buttons give the next Preset radio station down (0) or up (/). If the tuner is in Tune mode, these buttons decrease/increase the tuning frequency.
NOTE |
|
|
Remember to install the four AAA batteries supplied |
|
|
| AVR350 | |
before trying to use your remote control. |
| 19 |
|
|
|