Arcam AVR350 Using Zone, ‘Dimension’ is set to 3 for normal use, Display Centre spreading Effect

Main Menu Screen 2

Compression: Allows selection of three different compression ratios (off, medium

and high), where the higher compression is intended for ‘late night’ listening. The compression effect increases the volume of the quiet passages and decreases the volume of the louder passages. Compression can be disabled by setting this item to Off.

Compression is only available on Dolby Digital recordings and on some DTS recordings.

Lip Sync: Allows the introduction and adjustment of a time delay between the audio and video signals to compensate for the sound and picture not being

synchronised. This may be required when extra video processing is used in the system, for line doubling or progressive scan video, or for when a DVD has been poorly mastered or a broadcast shows noticeable delay between the video and audio.

The lip sync function works on all sources, unless Stereo Direct is selected. Lip sync is also directly available on the SYN button on the remote control.

The range of lip sync delay is 0 to 220 milliseconds.The lip sync adjustment can only correct for delayed video: if the audio is delayed, set lip sync to its minimum.

Pro Logic IIx Music Mode: This allows the adjustment of the sound field for Dolby Pro Logic II/IIx

Music decoding of two-channel sources.

<Dimension: allows the user gradually to adjust the soundfield either towards the front or towards the rear. If a recording is too spacious or strong from the surrounds, it can be adjusted

����������	������	�����������	‘forward’ to get a better balance. Likewise, if a stereo recording
			is somewhat too ‘narrow’ sounding, it can be adjusted toward the
			rear to get a more enveloping, immersive result. We recommend
			‘Dimension’ is set to 3 for normal use.

<Centre Width: With Pro Logic decoding, dominant centre signals come only from the centre speaker. If no centre speaker is present, the decoder splits the centre signal equally to the left and right speakers to create a ‘phantom’ centre image. The Centre Width control allows variable adjustment of the centre image so it may be heard only from the centre speaker; only from the left/right speakers as a phantom image; or from all three front speakers to varying degrees. We recommend ‘Centre Width’ is set to 3 for normal use.

<Panorama Mode: Extends the front centre image to include the surround speakers for an exciting ‘wrap-around’ effect with side wall imaging.

Display	Centre spreading
	effect

0No centre spreading

120.8°

228°

336°

454°

562°

669.8°

7Phantom centre

The ‘Centre Width’ setting for Dolby Pro Logic IIx Music Mode

Main Menu screen 3

This page refers to Zone 2 functions. These are required if your system is installed to send audio and video to a separate ‘Zone 2’ room, or you wish to make use of the Zone 2 headphone facility.

Vol: Shows present volume being used in Zone 2 and can be adjusted from here. This is also the volume control for the headphones output if it is assigned to Zone 2.

Zone 2 Source: Selects which source is sent to Zone 2. The source can be selected specifically, or can be set to Follow Zone 1.

Note that pressing the THX button in Zone 2 will cause the input for Zone 2 to be set to ‘Follow zone 1’.

Using Zone 2

Zone 2 provides the option for the occupants of the master bedroom, children’s room or kitchen to view or listen to a different source at a different volume level from the main zone.

Control of Zone 2 is via an infra-red receiver that sends commands back to the AVR350. See ‘Control Connections’ on page 8 for further information.

AVR350

26