Listen Technologies AO 6004 Appendix, Technical appendix, Cabling, Analogue out XLR3 male

Danish Interpretation Systems User Manual

Appendix

Technical appendix

Cabling

CAT5

The DCS 6000 system uses CAT5, CAT5e or CAT6 FTP or STP cables with screened RJ45 connectors.

EIA 568-B wiring shall be used.

It is important to use only FTP or STP (screened) cables and screened RJ45 connectors and not UTP cable, which is unscreened.

How to wire a CAT5 (EIA 568-B) Cable:

Pin	Function	Connector #1	Connector #2
1	In-going +	ORG/WHT	ORG/WHT
2	In-going -	ORG	ORG
3	+48V	GRN/WHT	GRN/WHT
4	0V	BLU	BLU
5	0V	BLU/WHT	BLU/WHT
6	+48V	GRN	GRN
7	Outgoing -	BRN/WHT	BRN/WHT
8	Outgoing +	BRN	BRN

Note. If other colour codes are used then the four pairs are connected as follows:

Pair 1: Pin 1 & 2

Pair 2: Pin 3 & 6

Pair 3: Pin 4 & 5

Pair 4: Pin 7 & 8

The phase of the pairs must be correct and the wiring spec. as stated in CAT5 (EIA 568-B) have to be followed.

Note: CAT6 cables can normally only be terminated in sockets (female) and not in cable plugs. CAT6 should thus only be used for long cable draws terminating in wall outlets or patch panels.

Analogue out (XLR3 male)
Pin	Signal		Cable type
1	Ground	DIS type #2914
2	In phase signal	or 2 x 0,25 mm2
3	Out phase signal	shielded.
Accessories (not supplied)
EC 6000-..5 Connection Cable 0.5 m			10 03 12500
EC 6000-01 Connection Cable 1 m			10 03 13101
EC 6000-02 Connection Cable 2 m			10 03 13201
EC 6000-05 Connection Cable 5 m			10 03 13501
EC 6000-10 Connection Cable 10 m		.......................	10 03 14102
EC 6000-20 Connection Cable 20 m		.......................	10 03 14202
EC 6000-50 Connection Cable 50 m		.......................	10 03 14502

12 Manual 01 18 04442