LT-800 Quick Reference
LT-800 Front Panel: Controls & Displays
Adjust audio input levels of Input 1 and Input 2 here. See page 11 for more information.
Indicates | Top mount antenna connection: |
Remove rubber plug and screw | |
Process Mode | antenna in place. |
| is active. | Indicates |
|
| |
|
| LCD: Shows |
| ||
Indicates audio input | Super Quiet | which channel | Monitor Port: Plug | ||
mode is active. | is selected. | ||||
level of Input 1 and | Shows | in a headset and | |||
|
| ||||
Input 2. | mixed audio |
|
| adjust volume. | |
|
|
|
|
level.
QuSpeciRefficationsrce PackageQuick ReferenceContents
Power
ON / OFF Test Tone: Activates
a tone to aid system
setup.
Mix Level: Adjust so the Mix Level meter occasionally lights the red LED.
Contour: Equalization adjustment. Turn
Channel Select Up: Press for 3 seconds to lock on current channel.
Channel Select Down: Press for 8 seconds to enter program mode. See page 8 for more information.
LT-800 Back Panel: Connections & Settings
Remote Antenna Connection: See page 22 or the Listen website for details on antennas that can be attached here.
Mix Output: These connectors contain a mix of Input 1 and Input 2. They are unbalanced phono connectors; and the output level is
Input 2: Set switch to match the level of your Input 2 audio source, not used to increase or decrease level by +10dBu.
Input 1: Used for balanced connection of a microphone or line level input. This combination connector accepts either XLR or ¼” phono plugs.
Set RF Power level here (¼, ½, and Full). See page 9 for guidelines on setting power levels.
12 VDC . A
The Listen
Input 2: Connect unbalanced audio to these phono connectors, input level
Select Line, Mic or Mic+Phantom Power. Line is balanced 0 dBu input level, Mic is
If not using input 1, leave in line position.
6