Initial installation
Installing the TV set
First prepare the chosen installation solution for your TV set. See the installation instructions of the wallmount supplied. See Accessories (page 55) for other installation possibilities.
Removing the protective foil
Slowly and carefully remove the protective foil on the trim.
Preparing the remote control unit
Inserting or replacing batteries
Press the embossed arrow and push down the battery compartment cover.
Insert two alkaline manganese LR 03 (AAA) batteries; ensure that the + and – poles are correctly positioned!
Slide the cover up from below.
LR03 | AAA | |
AAA | ||
| ||
LR03 |
|
Adjusting the remote control for operating the TV set
Press the TV button.
See page 50 to learn about operating other Loewe devices.
Connecting the TV set
Connecting to the mains
➠Note the position of the mains connection in Individual Compose 40 / 46.
Remove the cover for the connections.
Connect the TV set to a
First plug the small plug of the mains cable into the mains connection on the rear of the TV, then plug the large plug into a mains power outlet.
Connecting the antenna
Analogue /
Plug the antenna plug of antenna system, cable system, or room antenna into the ANT2 socket.
The connecting cable between
Satellite antenna:
Connect an antenna plug, e.g. from the antenna change- over switch or from the
When connecting only one SAT antenna cable, connect it to
ANT2 |
|
|
| Individual Compose: 40 / 46 | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ANT | ANT | |
SAT2 | SAT | |
|
| 50/60Hz |
TV
R
Connections on the back of the set (see also page 5).
Replace the cover over the connections.
Connecting speakers
How to configure and connect TV speakers, speaker systems or active speakers is described from page 39.
Receiving coded stations
When using a CA module and a
- 10
