![](/images/new-backgrounds/1133116/13311623x1.webp)
First installation | Daily operation |
Directing DVB-T antenna
Note: not with
If you use a room antenna to receive one or more
To help you direct your antenna or to help you determine the most suitable loca- tion to set up the antenna, your TV set has a display for the signal quality C/N
Switching on/off
Your TV is equipped with an
and the signal strength Level.
Consult your specialist dealer to find out which channels and frequency bands (VHF or UHF) are used to broadcast the digital TV stations in your area.
On any one channel, several digital stations are broadcast.
Select a TV channel
1.Call the “TV menu“ via the MENU button.
2.Use 34 to select “Settings“, then use 6 to select the menu line underneath.
3.Select “Stations“, then use 6 to select the menu line underneath.
| TV menu |
| INFO END |
| Settings |
| |
|
|
| |
| Stations | Parental lock Timer functions Language | |
| Manual adjustment | ... |
|
|
|
|
|
4. Select “Manual adjustment“ and call the menu using OK (not possible for
Manual adjustment |
|
|
Signal source |
OK
Switching off
If the TV set is switched on, you can switch it to standby using the blue ON/OFF button on the remote control. The red lamp on the TV set lights up. If the orange indicator lights up, a timer recording is being made, EPG data is being captured or radio operation without screen display is active.
Switching on the TV set
From standby, it is best to switch the set back on using the blue On/Off button or by using the numeric buttons of the remote control (0 – 99).
The green indicator on the TV set lights up.
Or switch on the TV set with OK, you can then see the station list and select a station.
Switching the radio on
Channel | E 05 | ||
Frequency | 177.50 MHz | ||
Name | Test | ||
Bandwidth | 7 MHz | ||
C/N 96 |
|
| Level 99 |
END
5.For digital stations, select “Signal source – DVB-T“.
6.Use the numerical buttons to specify the corresponding channel number. Depending on the channel selected and country, the system automatically sets the corresponding bandwidth of 7 or 8 MHz. You should only change the bandwidth under special circumstances - if the channel raster in your area is different from the standard.
When you receive a digital station, the system displays the signal quality C/N via a bar/numeric value and the signal strength via Level. The anten- na‘s direction or position is best when the largest values possible are displayed (long bar) for the signal quality and signal strength.
7.Direct the antenna so that the largest numerical value/bar size is reached.
8.If no signal is found in the channel set, you can start the frequency search run by pressing the blue button within the band selected (VHF or UHF).
9.Check the other channels one after another on which digital stations are broadcast terrestrially in your area.
For the weakest station, direct the antenna so that the maximum numerical value/bar size is achieved.
10.After you position or direct the antenna, we recommend to search for all the stations using the “Search wizard“ (TV menu – Settings – Stations – Search wizard).
RADIO With the RADIO button on the remote control.
If you switch off the TV set using the mains switch on the set, the indicator no longer lights up.
If the TV set is switched off via the mains switch, you have to switch it into the standby mode fi rst via the mains switch and then switch it on using one of the above mentioned methods.
- 12