Loewe ConceptL26, ConceptL32 manual Operating additional equipment, Login and connect equipment

Operating additional equipment

Login and connect equipment

You have logged in and connected all connected equipment in the initial instal- lation. If you want to connect other equipment or disconnect equipment, call the connection wizard.

MENU	Call up the TV menu
OK	Select “Connections”
OK	Select the submenu line
OK	Select “New devices/modifications” and ...
OK	Call with OK.

State what equipment you want to connect. State whether a piece of audio equipment is to be connected (more details as of page 31). The connection wiz- ard then shows you which sockets you should connect this equipment to. Then connect the equipment to these sockets according to the connection diagram.

Connecting video/DVD recorders

In addition to the connection via the Euro-AV sockets, you also have to connect the antenna (only for terrestrial antenna or cable systems) through the VCR/DVD recorder to the TV set. The antenna signal is then available to the video/DVD recorder and the TV set.

Note: Use Euro-AV cables with right-angled plugs as shown.

ANT AV1

			ENTREE
EURO AV2			ANTENNE
DECODER
	AUDIO		AERIAL
	SORTIE	OUT
EURO AV1	G	L	SORTIE
AUDIO/			ANTENNE
VIDEO	D	R

RF OUT

Search for and store the station of the video recorder (if no Euro-AV cable is available)

Switch on the test station on the VCR or insert a recorded tape and start play- back. In some video recorders the station must be switched on by activating the modulator.

Then call the AV selection on the TV set with 0 AV. Select the menu item “VIDEO” in the AV selection and call using OK.

To prevent “normal” TV stations being found in the search, pull out the antenna plug from the antenna input of the VCR temporarily (the cable to the antenna system).

If you cannot see the test station or playback from the cassette, the VCR is transmitting on a different channel. You then have to search for the station or set it manually.

1.Call the TV menu with the MENU button.

2.Select the “Settings” menu item with 34.

3.Select the line below using 6 and use 34 to select “Stations”.

4.Select the line below using 6and select “Manual adjustment” using 34 and call this menu using OK.

5.Enter channel “E30“ under the “Channel“ menu item (“Antenna/cable (analogue)”, select in this menu above if necessary).

6.Start search with the blue coloured key.

7.When the station has been found, change the name if needed, confirm with

OK and save with the red coloured key.

8.A list of the stored stations is displayed.

9.Select 0 (VIDEO) here and overwrite this station storage location using the red coloured key.

10.Hide the menu again using the END button.

Plug the antenna plug back in.

If you now get interference because a TV station is transmitting on the same channel as the VCR station, you have to change the transmitting station on the VCR and search for the VCR station on the TV again.

29 -