Initial Installation

Connecting a digital camcorder

You can connect a digital camcorder (DV) or a digital DVD-R/RW recorder to the DV IN socket and transfer contents of DV tapes or DVDs digitally.

Use a DV cable (not included in delivery) to connect the DV IN-/OUTsocket of your DV-camcorder/video deck to the DV IN socket on the front control panel of this recorder.

➠Only DV units can be connected to this socket (the source signal must be in the DV-25 format; see page 53). It is not compatible with digital satellite tuners or S-VHS video decks.

DV Digital Camcorder

DV

IN/OUT

Front of the recorder

Connect to the mains

First plug the small plug on the power cable into the mains connection on the back of the recorder then plug the large mains plug into a 200-240V/50-60Hz mains socket.

Basic Settings

Set the remote control for recorder operation.

Push the On/Off button on the DVD recorder or

the On/Off switch on the remote control.

➠If you aim the remote control at the recorder when switching over to Recorder mode, the recorder will be switched on.

Concealed installation

With Digital Link, Loewe TV sets pass on the signals from the remote control through the Euro-AV connection on the recorder. Digital Link is useful when you want to put the recorder in a concealed place, e.g. in a closed rack.

➠Your recorder must be switched on. Button on the recorder for > 3 s

Digital Link on: LINK appears in the recorder display.

Digital Link off: FRONT appears in the recorder display.

Resetting the DVD Recorder

If any of the following problems occur.

•The unit is plugged in but will not turn on or off.

•The display panel does not work.

•The Recorder is not functioning normally.

the Recorder can be reset in the following way:

Hold down the button on the device for at least five seconds. The device switches off or pull out the power cable, wait at least 20 seconds and reconnect the cable.

Press the button again to switch the device back on.

- 20