Logitek Standard Elec. Cable Manufacturing C/A210 operation manual Starting and Maintaining a Fire

Figure 8

Figure 9

Starting and Maintaining a Fire

Be sure to clean the Nickel or Gold Plated door with Win- dex brand cleaner and a very soft cloth to remove any fingerprints and residues prior to the first fire.

1.NEVER USE FLAMMABLE LIQUIDS TO START OR REKINDLE A SOLID FUEL FIRE!!

2.Fully open the primary draft control by pulling the 1” plastic knob out on the left side (lower front corner) until it stops (away from the stove). This control determines the amount of air entering the stove. Pushing it toward the stove reduces the burn rate in the firebox. For your convenience, the rod on this control is marked with four grooves to assist you in obtaining repeatable burn rates.

3.Place a small amount of crumpled paper in front of the firebox and cover it with a few pieces of kindling.

4.Light the paper and allow sufficient time for the kindling to become fully engulfed in flames. Close the door. Your door may or may not need to be left slightly open during this process, depending on your stove model and chimney draft. Once the kindling is burning well, larger pieces of wood may be added.

5.For best results, use smaller pieces of wood to get stove temperature very high before loading larger wood for sustained burns. If necessary, crack the door to allow ignition of the fuel charge. Now you can add larger pieces of wood and after several minutes of high burn, set the left control for the desired heat output. Check the exhaust in about 15 to 20 minutes. Large amounts of smoke indicate an improper burn setting (either too high or too low) Adjust and recheck in 5 to 10 minutes.

6.After your stove has been thoroughly preheated, your blower can be switched on. When refueling your stove, turn the blower off for the first 30 minutes. On low and medium-low burns run the blower on low. These burn rates would be achieved by operating the stove with the draft rod fully pushed in to up to 3/4” (19mm) open (out). To do this, turn on the blower at the speed control and rotate the control all the way to the right. On medium-high and high burns you may run the blower on high. These burn rates would be achieved by opening the draft rod further than stated previously. To do this, turn on the blower with the speed control and do not rotate the switch after it clicks on.

12

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.