Logitek Standard Elec. Cable Manufacturing C/A210 Figure Mantel Trim, Combustible Mantel, Insert

Required Clearances

WARNING: BE ABSOLUTELY SURE THE DISTANCE BE- TWEEN THE HEATER AND THE SURFACE OF ANY COM- BUSTIBLE CONSTRUCTION IS NOT LESS THAN SHOWN ON THIS PAGE.

Model	*A	*B	*C	*D	E(1)
C/A210	USA-24”	USA -18”	18”	15”	USA-8"
	CAN-813mm	CAN-660mm	450mm	381mm	CAN-200mm
C/A210 w/	USA-16”	USA -10”	18”	USA-8”	USA-8"
mantel	CAN-813mm	CAN-660mm	450mm	381mm	CAN-200mm
and/or side
shields u

Model	F (1)	G	H	J(2)	M
C/A210	18”	12-1/4”	19”	4-1/2”	42-1/8”

Maximum Mantel Depth = 9” (229 mm)

COMBUSTIBLE MANTEL

	Top Facing / Trim
	Side Facing Material	B	A
SIDE WALL		D
	C		Insert
			Hearth Protection

	E (Canada)
E (USA)

	450mm	311mm	483mm	114mm	1070mm
C/A210 w/	18”	12-1/4”	19”	4-1/2” 34-1/8”
mantel and/or	450mm	311mm	483mm	114mm	867mm
side shields u

*Reduced clearances may be available for A, B, C and D dimensions per NFPA 211 - latest edition, Standard for Chimneys, Fireplaces, Vents, and Solid Fuel-Burning Ap- pliances (in Canada CSA B365 - latest edition). See section on “Reduction of Appliance Clearance with Specified Forms of Protection.”

**Side view of optional mantel deflector shown.

(1)Hearth extension reductions: 2” (51mm) reduction for 2” (51mm) raised hearth. (USA) 16” minimum hearth exten- sion on all stoves as measured from the door opening of the unit. (Canada) 18”(450mm) minimum hearth extension on

Figure 4

Mantel

Trim

**

M9” 229mm

F

G

J

H

all stoves as measured from the door opening of the unit. Minimum distance of floor protection to the side = 8” (200mm). This is measured from the sides of the door opening in the USA and from the sides of the insert in Canada.

(2)J = Maximum lintel depth without flue offset or smoke deflector.

Hearth Protection

Hearth Protection

Figure 5

Top View

The hearth and/or floor protection must be a thermally rated non-combustible hearth/floor protector meeting or exceeding a thermal rating of k=.84 or equivalent with a listed thickness of 3/8" (9.5mm) minimum in USA (3/4" - 19mm minimum in Canada). The covering must extend 18” (450mm) in front of the heater and 8” (200mm) to either side (measured from door opening in the USA and measured from the side of the unit in Canada).

Notes:

•Facing material that projects more than 3/4” (19mm) from the wall is considered a mantel or side wall.

•MINIMUM FIREPLACE OPENING 19-1/2” (495mm) High x 26” (660mm) Wide

Figure 6

23”

584mm

25-1/2” 648mm

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.