While recording, a pulse signal(DC 5V) is output at the SW OUT terminal after each recording period. This terminal is usually connected to the switch input of devices like a camera switching unit, or a quad compressor.
1)Low
2)High
SERIES OUTPUT TerminalDuring recording, when the end of the tape is reached, the output becomes DC 5V .
SERIES INPUT TerminalIf the input becomes DC 5V for 200 msec or more, the VCR starts series recording.
WARNING OUTPUT Terminal1)“High”
If the error display on the display panel continues to flash, the output becomes DC 5V. If the POWER button is pressed, the emergency mode is released. then the output becomes 0V.
2)“Low”
If the error display on the display panel continues to flash, the output becomes 0V. If the POWER button is pressed, the emergency mode is released. then the output becomes DC 5V.
1AC POWER CORD
2WARNING OUT terminal
3SERIES IN terminal
4COM terminal
5SERIES OUT terminal
6SW OUT terminal
7VIDEO OUT jack
8VIDEO IN jack
9AUDIO IN jack
10TAPE END terminal
11PANIC IN terminal
12COM terminal
13ALARM OUT terminal
14ALARM IN terminal
15MIC (microphone input) jack
16AUDIO OUT jack
35 | 4 |