Connecting PTZ Cameras - Appendix #5
Connecting PTZ Cameras - Appendix #5
PTZ Cameras (not included with this system) can be connected to the PTZ Control Block on the back panel of the System. The PTZ Controls are enabled through the Menu system on the Observation System. Additional PTZ Cameras are available at http://www.lorexcctv.com
Installing a PTZ (RS-45 Type) PTZ Camera:
1.Connect the Transmit Cable to the D+ port on the PTZ Control Block on the Observation System.
2.Connect the Receive Cable to the D- port on the PTZ Control Block on the Observation System.
3.Connect the Camera to BNC Channel 1 (DIN Channel 1 must be empty).
OBSERVATION SYSTEM
PTZ CAMERA (Not Included)
4.Configure PTZ Menu options - refer to page 25. The PTZ Camera Settings will depend on the Type of Camera - refer to the specific Camera Manual for your brand and model of PTZ Camera.
•MODEL - Select a PTZ protocol
•PTZ ID - Enter the PTZ’s ID / address.
•BAUD RATE - Enter the PTZ’s transmission baud rate
•CMD DELAY - Set the delay time of the command transmission between bytes. Please refer to the PTZ user manual for the manufacturer’s recommendations.
50
