Louisville Tin and Stove 78111 Contents, Introduction, Counterflow Wall Furnace Specifications

The State of Massachusetts requires that installation and service of a gas appliance be performed by a plumber or gas fitter licensed in the Commonwealth of Massachusetts.

CONTENTS

Contents……………………………………………........... 2		Lighting & Re-Lighting Instructions……………….. 10,11
Introduction…………………………………………. 2		Operation………………………………………….....….	12
Specifications………………………………………..	2	Terminal Block Wiring Diagram……………….....…… 13
Safety Rules…………………………………………	3	ManualReset…………………………………....……..	13
Helpful Installation Information……………….........….	3	Maintenance Instructions…………………….………	13
Connecting theVent……………………………....…..… 3,4		WiringDiagram……………………………….....……..14,15
Combustion and VentilationAir	5	Side & Rear Discharge Kits……………………...……16,17
FurnaceLocation………………………………….....….	6	Trouble Shooting Chart…………………………..….. 18,19
Rough-In Instructions…………………………..…..…. 6,7		Repair Parts (break down)………………………..….. 20-24
Installation……………………………………….......…..	8	RepairPartsList…………………………………....….21-25
Controls…………………………………………........…..	9	Warranty………………………………………….....….	27
Pilot Flame Adjustment…………………………......…..	9

INTRODUCTION

THIS ISAGAS-FIRED, GRAVITYVENTED WALL FURNACE THAT WILLOPERATE SAFELYAND PROVIDEAN EFFICIENT SOURCE OF HEAT WHEN INSTALLED, OPERATEDAND MAINTAINEDAS RECOMMENDED IN THESE INSTALLATION AND OPERATING INSTRUCTIONS. READ THESE INSTRUCTIONS THOROUGHLYBEFORE INSTALLING, SERVICING, OR USING THE APPLIANCE. IF YOU DO NOT UNDERSTAND ANY PART OF THESE INSTRUCTIONS CONSULT LOCAL AUTHORITIES, OTHER QUALIFIED INSTALLERS, SERVICEAGENCIES,THE GAS SUPPLIER, ORTHE MANUFACTURER.

COUNTERFLOW WALL FURNACE SPECIFICATIONS

Your counterflow wall furnace is packed in a single carton that also includes thermostat, thermostat wire, and insulated staples. The thermostat, wire, and staples are packed in the burner compartment and are accessible by removing the burner access door. While the burner access door is open, check the rating plate to verify that the model number is correct and that the wall furnace is equipped for the type gas you intend to use.

			Vent						Approx.
Model Type	Type	BTU/HR.	Size	Gas		Blower			Shipping
Number Control	Gas	Input	(Oval)	Inlet	Finished Dimensions	Speed	Amps	CFM	Weight
	MODELS WITH LOW-BTU STANDING PILOT
CF353C-H 24Volt Nat.		35,000	4”	½” 14-5/16”Wx10¼”Dx78-5/8”H		1	1.95	320	95 Lbs.
CF354C-H 24Volt L.P.		35,000	4”	½” 14-5/16”Wx10¼”Dx78-5/8”H		1	1.95	320	95 Lbs.
CF503C-H 24Volt Nat.		50,000	4”	½” 14-5/16”Wx10¼”Dx81-5/16”H		2	2.25	440	104 Lbs.
CF504C-H 24Volt L.P.		50,000	4”	½” 14-5/16”Wx10¼”Dx81-5/16”H		2	2.25	440	104 Lbs.
CF653C-H 24Volt Nat.		65,000	4”	½” 14-5/16”Wx10¼”Dx87-5/16”H		2	2.25	440	107 Lbs.
CF654C-H 24Volt L.P.		65,000	4”	½” 14-5/16”Wx10¼”Dx87-5/16”H		2	2.25	440	107 lbs.
		MODELS WITH INTERMITTENT IGNITION
CF357C-H 24 Volt Nat.		35,000	4”	½”	14-5/16”Wx10¼”Dx78-5/8” H	1	2.2	320	95 Lbs.
CF358C-H 24 Volt L.P.		35,000	4”	½” 14-5/16”Wx10¼”Dx78-5/8”H		1	2.25	320	95 Lbs.
CF557C-H 24 Volt Nat.		55,000	4”	½” 14-5/16”Wx10¼”Dx87-5/16”H		2	2.5	440	107 Lbs.
CF558C-H 24 Volt L.P.		55,000	4”	½” 14-5/16”Wx10¼”Dx87-5/16”H		2	2.55	440	107 Lbs.

Page 2