ROUGH-INS FOR REAR OR SIDE DISCHARGE
Install plastergrounds as shown in Figure 12 and Figure 13.
NOTE: When side discharge is being used, furnace should be set exactly 4” from side wall.
1/2”
Plaster
Ground
REAR
FIGURE 12
Plaster
Ground
SIDE
FIGURE13
OPTIONAL ACCESSORY KITS
REAR REGISTER KIT (Flush Mount)
(See Figure 14)
1.Use optional kit No.
2.Cut openings in drywall as shown in Figure 12.
3.Position plasterground as shown in Figure 12 (Optional).
4.Cut out and remove embossed section on casing rear.
5.Remove knockout on inner liner.
6.Put heater into position.
7.Place inner boot into position, mark and cut boot flush with wall. Place damper into cutout end of inner boot, mark (4) holes from damper onto inner boot, top and bottom, and drill (4) 1/8” hole. Place outer boot into position, mark and cut boot flush with wall.
8.Attach inner boot to liner. Attach damper to inner boot (screws provided). Attach outer boot to casing back.
9.Place grill in position and secure to wall.
10.Final installation will appear as Figure 14.
REAR DISCHARGE KIT (Recessed)
1.Use optional kit No.
2.Cut openings in wall as shown in Figure 13.
3.Cut out and remove embossed section on casing rear.
4.Remove knockout from inner liner.
5.Place inner boot from kit through opening, matching flanges of boot and knockout.
6.Mark screw holes and remove boot.
7.Drill holes with a 1/8” drill.
8.Repeat steps 5 & 6 for outer boot.
9.After unit has been set in wall, shove the inner boot through the back wall and up against the liner. Secure boot with screws provided. Attach damper to inner boot with screws provided.
10.Repeat Step 9 for outer boot.
11.Place grille in place and secure to wall.
12.Final installation will appear as Figure 15.
(OPTIONAL KITS CONTINUED - REVERSE SIDE)
FIGURE 14 |
| FIGURE 15 |
|
| Page 16 |
