FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHATTO DO IFYOU SMELLGAS:
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
PN 91214 02/05
LIGHTING INSTRUCTIONS
1.STOP! Read the information on the safety label.
2.Set thermostat to lowest setting.
3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
5.Remove lower front panel.
6.Push in gas control knob slightly and turn clockwise
to “OFF”.
Gas Control Knob
NOTE: Knob cannot be turned to “OFF” unless knob is pushed in slightly. Do not force.
7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the information on the safety label. If you don’t smell gas, go to the next step.
8.Turn gas control knob counterclockwise 
to “ON”.
GASCONTROL
KNOB
9.Replace lower front panel.
10.Turn on all electric power to the appliance.
11.Set thermostat to desired setting.
12.If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO APPLIANCE” and call your service technician or gas supplier.
PN 91214 02/05
TO TURN OFF GAS TO APPLIANCE
1. | Turn thermostat to it’s lowest setting. | 4. | Push in gas control knob slightly and turn clockwise |
2. | Turn off all electric power to the appliance if |
| to “OFF”. Do not force. |
| service is to be performed. | 5. | Replace lower front panel. |
3. | Remove lower front panel. |
| PN 91214 02/05 |
Page 11
