Special Note: The
stylus may
be damaged if the transport
assembly is pulled down
unless the stylus has been
moved to the back side of the
platen.
4. Pull out and down on the tab
at the top center
of the
platen
assembly to expose the
paper
spools. (See Figure 26).
5. To remove the full take-up roll
and the empty supply spool,
press the two metal tabs
together on the top of the
transport
assembly, and pull
out and down on the paper
retainer. (See Figure 24). The
full take-up roll can now be
easily removed from the
paper
core shafts. (See Figure 27).
6. Pull the empty supply
core
from the right side in the same
manner Install the
empty
core
onto the take-up shaft. (See
Figure 29). Align the two
notches in the core with the
tabs on the lower
take-up
spool.
7. Slide a fresh roll of Lowrance
chart paper
in position
on the supply side shaft
on the right side of the
platen
assembly. The paper
must
spool off the bottom of the roll.
(See Figure 30).
NOTE: Use Lowrance LPG-605 or
LPG-606 chart paper only.
8. Draw the end of the paper
across the face of the platen,
around the friction roller, over
the take-up core, and tape it
squarely to the take-up
core.
(See Figure 31). Small pieces
14 15
of
tape may be stored inside
the housing for this purpose.
Close the top of the transport
assembly by pressing the two
tabs together on the paper
retainer and returning the
retainer back to the operating
position. (See Figure 32.)
•0 FIGURE 26
9. Turn the small knob at the
upper left hand side of the
transport assembly to put a
small amount of tension on the
paper. It should be snug
against the platen. (See
Figure
33.).
FIGURE 29 FIGURE 31 FIGURE 33
PDF compression, OCR, web-optimization with CVISION's PdfCompressor