1.4 Troubleshooting
During installation, no SCSI devices are found:
∙Check the cable connections and the host bus adapter installation.
∙Ensure that all devices are powered on and terminated correctly.
∙Check that no devices have duplicate SCSI IDs.
∙Make sure INT A is assigned for the PCI slot(s) where your SCSI host adapter(s) are installed.
∙Make sure the SCSI device driver is installed properly.
The computer hangs or locks up when booting and the SCSI devices attached are not seen by the computer system:
∙Make sure that all the SCSI devices are configured at different ID numbers (the boot drive should have the lowest ID).
∙Make sure both ends, but only the ends, of the SCSI bus are terminated.
∙(DOS, OS/2) Make sure the device driver is listed in CONFIG.SYS (and loaded when booting).
The device driver does not see one of the SCSI devices:
∙Reboot the computer.
∙Make sure the SCSI devices have different ID numbers (the boot drive should have the lowest ID).
∙Make sure both ends, but only the ends, of the SCSI bus are terminated.
∙Check the cable and power connections.
What is Covered in this Guide |
