LSI S14037 manual Completing the Installation

1.2.1 Completing the Installation

Step 1. The bracket around the end connector (J3) should fit where the blank bracket panel was removed. Secure the bracket with the bracket screw.

Step 2. Replace the cover as described in your computer documentation.

1.2.2 Connecting External SCSI Devices

Step 1. If you need to connect external SCSI devices to the SYM20810 host adapter, plug the 50-pin connector on one end of a shielded external SCSI cable into the host adapter SCSI connector J3. This connector is now bracketed to the back panel of your computer. Figure 1.4 shows how this connection is made.

Step 2. Plug the 50-pin connector on the other end of the SCSI cable into the SCSI connector on the peripheral device. This connection is shown in Figure 1.4.

Step 3. If you wish to connect more than one device to the host adapter, use shielded cables to chain them together as illustrated in Figure 1.4.

Step 4. Terminate the SCSI bus as described in the section Section 1.2.3, “SCSI Bus Termination,” page 1-9.

Connecting Internal SCSI Devices 1-7