2.2Hardware Requirements

You must have the following items to install and use a MegaRAID SATA

150 storage adapter:

A MegaRAID SATA 150 storage adapter and device driver

Host computer with an available PCI expansion slot

Serial ATA disk drives and cables

2.3Quick Installation Instructions

Follow these instructions to install your SATA 150 storage adapter if you have prior experience installing computer hardware.

Step 1. Unpack the MegaRAID storage adapter and inspect it for damage.

Step 2. Power down the system and disconnect the power cord.

Step 3. Remove the cover from the computer.

Step 4. Configure the jumpers on the SATA 150 storage adapter.

Step 5. Insert the MegaRAID SATA 150 storage adapter in an available PCI slot.

Step 6. Configure the Serial ATA devices according to the instructions for each device.

Step 7. Connect the Serial ATA cables between the SATA 150 storage adapter and the Serial ATA devices.

Step 8. Replace the computer cover, reconnect the power cord, and power up the system.

2-2

Hardware Installation

Copyright © 2002–2006 by LSI Logic Corporation. All rights reserved.