
Recalling Memory
1. To recall stored blood pressure readings from memory, simply press the Memory button. The last set of memorized readings will be displayed.
2. Another press of the Memory button will recall the previous set of readings.
3. All readings stored in memory will be displayed with its sequence number.
Helpful Tips
Here are a few helpful tips to help you obtain more accurate readings:
•Do not measure your blood pressure immediately after consuming a large meal. To obtain more accurate readings, please wait one hour before measuring.
•Do not smoke or drink alcohol before measuring your blood pressure.
•You should not be physically tired or exhausted while taking a measurement.
•It is important that you relax during measurement. Take a
•Do not take measurements if you are under stress or under tension.
•Take your blood pressure at normal body temperature. If you are feeling cold or hot, wait a while before taking a measurement.
•If the monitor is stored at very low temperature (near freezing), have it placed at a warm location for at least one hour before using it.
•Wait about 5 minutes before taking the next pressure measurement.
If any abnormality should arise during use, please check the following points:
Troubleshooting
Symptom | Check Point | Correction | |
No display when the | Have the batteries run down? | Replace with two new batteries | |
POWER button is pressed |
|
| |
| Have the batteries’ polarities been | ||
| positioned incorrectly? | positions. | |
EE mark shown on display | Is the cuff placed correctly? | Wrap the cuff properly so that it is | |
positioned correctly. | |||
or the blood pressure value |
| ||
Is the cuff pressure pumped enough? | Measure it again and pump up 50~60 | ||
is displayed excessively | |||
| |||
(50~60 mmHg above normal systolic | mmHg more than normal systolic | ||
low (high) | value?) | value. | |
| Did you talk or move during |
| |
| measurement? | Measure it again quietly. | |
| Did you shake the arm with the cuff on? | ||
|
| ||
|
|
|
7