Manuals / M-Systems Flash Disk Pioneers / Computer Equipment / Flash Memory

M-Systems Flash Disk Pioneers IDE 4000, Flash Disk user manual Interface Connectors, IDE Cable

Models: IDE 4000

1 23

Page 14

3.INTERFACE CONNECTORS

The IDE 4000 has a 2-mm pitch interface connector located on the rear panel. It accesses the DC power source and the IDE bus through a non-shielded 44-pin flat cable. Figure 6 provides an example of a connector that can be used to interface with this connector, but any compatible connectors may be used.

Figure 6: IDE 4000 Interface Connector

In order to prevent damage to the disk by connecting the cable with a 180º rotation, ensure that the special plastic key at pin 20 mating connector is blocked, as shown in Figure 6. This key should be ordered from the connector manufacturer.

IDE Cable

The cable length should not exceed 18 inches.

Product Specification and User Manual IDE 4000 Flash Disk

34-PS-0304-00 Rev. 2.1

Page 14

Image 14

M-Systems Flash Disk Pioneers IDE 4000, Flash Disk user manual Interface Connectors, IDE Cable

Contents

January 34-PS-0304-00Rev IDE 4000 Flash DiskDCO No Title DOCUMENT CONTROL INFORMATIONREVISION HISTORY NameTABLE OF CONTENTS Ordering Information WarrantyHow to Contact Us 34-PS-0304-00Rev.1.1. Critical Item Definition 1.2. Characteristics1.SPECIFICATIONS 1.2.1.Interface Definition1.2.6.Input Voltage 1.2.4.Access Time1.2.5.Seek Time 1.2.7.Current ConsumptionTable 5 IDE 4000 Flash Disk Capacities 1.2.8.Memory CapacityTable 4: CHS Settings for Low-CapacityIDE 1.2.10.Mean Time Between Failures MTBF 1.2.11.Physical Characteristics1.2.9.Endurance 1.2.11.1WeightFigure 3 IDE 4000 1.8” Assembly Notes: 1. All dimensions are in mm inFigure 2 IDE 4000 2.5” Assembly 2. General tolerance is ±0.25 mm ±0.01 inTable 10 J2 Pin Assignment 1.2.11.3 Connector InterfaceTable 9 J1 Pin Assignment 1.3.1.Temperature 1.3. Environmental Conditions1.3.4.Shock 1.3.2.Altitude1.3.3.Relative Humidity 1.3.5.Vibration34-PS-0304-00Rev 2.DRIVE CONFIGURATIONFigure 5 IDE 4000 Disk Address Setting by Jumper 3.INTERFACE CONNECTORS IDE Cable4.SUPPORTED IDE COMMANDS Table 11 IDE CommandsEN 55022 Class B, CISPR 22 Class B MIC 5.CE AND FCC COMPATIBILITYFCC Part 15 Class B BSMI CNS 13438 Class B Taiwan3.Unformatted capacity value 4.M-Systemslogo 6.LABEL INFORMATION1.CE and FCC logos 2.Product name 5.Ordering informationTo install the IDE 7.3. Installing the Drive in a PC7.USING THE IDE 4000 FLASH DISK 7.1. Unpacking the Drive7.5. Troubleshooting 7.6. How to Get Help 8.WARRANTY 34-PS-0304-00Rev9.ORDERING INFORMATION Japan HOW TO CONTACT USChina Europe