Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
1The door must be closed and locked into place to select a LOAD SELECTION or an OPTION.
2If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the door is closed and latched into place.
Start
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and display the last settings you selected.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
Clean
This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.
Flashing Display Lights
Lights | What It Means | What To Do | |
|
|
| |
| This is normal. | Allow the dishwasher to drain and reset before you start a new | |
| |||
| The START/RESET pad | wash cycle. | |
START | has been pressed. |
| |
RESET |
|
| |
|
|
| |
|
|
| |
| Control Error | Press the START/RESET pad to turn off the beeper. If the CLEAN | |
| CLEAN | |||
| light continues to flash, call for service. | ||
|
|
|
PLUS A
BEEPING
SOUND
Control Error | Press the START/RESET pad to turn off the beeper and the |
| dishwasher will attempt to reset. Restart the wash cycle. |
| If this error continues, turn off the power to the dishwasher at |
| the circuit breaker for 30 seconds. Try the dishwasher again. |
| If the error is still present, call for service. |
PLUS A
BEEPING
SOUND
8
