Care and cleaning. | www.GEAppliances.ca |
In the Event of a Power Failure
Safety
If the power fails, open the door as infrequently as possible to maintain the temperature. A gradual rise in temperature should not have any adverse effect on the wine.
If it is extremely hot, you may want to unload the wine from the wine chiller and move the wine to a cooler location until power is restored.
When power is restored, the controls automatically are set to the Factory Setting 50°F (10°C). If needed, reset the controls to the desired setting.
Instructions
Preparing to Move
Unload the wine, then secure the racks | Be sure the wine chiller stays in an upright |
and door by taping them in place to | position during the move. |
prevent damage. |
|
Replacing the light bulb (available on some models)
Unplug the wine chiller.
2If the door is locked, unlock it.
3The light bulb is located behind the Light Shield in the ceiling of
the wine chiller near the front. To remove the light shield, remove Screw.Gently pull down on the bottom of the Light shield to release it.
4 Unscrew the light bulb from the Socket.
5Replace with a 10 watt, 120 volt refrigerator bulb. This type of bulb is available at most hardware and automotive parts stores.
WARNING: Using a bulb rated higher than 10 watts may damage the wine chiller
6Attach the Light Shield to the Bulb Housing with Screw .
7Plug the wine chiller back in.
LED Refrigerator Lights (available on some models)
An authorized technician will need to replace the LED light
7
Operating Instructions Care and Cleaning
Troubleshooting Tips |
Consumer Support