Mabe Canada GWS04 Installing the wine chiller, Safety Instructions, Installation, Leveling Legs

Safety Instructions

Installing the wine chiller.

Removing the Packaging

Before using the wine chiller, be sure all packing materials and tape have been removed, including any protective film covering the control and any film protecting the cabinet.

If you are discarding an old refrigeration product, remove the doors to reduce the danger of children being trapped inside.

Installation Instructions

Operating Instructions

Installation Guidelines

The wine chiller must be freestanding.

Allow the following clearances for ease of installation, proper air circulation and electrical connections:

Each side	2" (51 mm)
Top	2" (51 mm)
Back	3" (51 mm)

Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transporation.

Do not install the wine chiller where the temperature will go below 55°F (13°C) or above 90°F (32°C).

Install it on a level floor.

Do not install the wine chiller where it will be subject to direct sunlight, heat or moisture.

Do not store or install this appliance outdoors.

The following models must be installed on the floor: GWS04, GCS04.

Care and Cleaning

Troubleshooting Tips

Consumer Support

Leveling Legs

Adjustable legs at the front corners of the wine chiller should be set so the wine chiller is firmly positioned on the floor, with a 1/8" (3 mm) tilt to the back to help the door closure.

To adjust the leveling legs, turn the

To raise the wine chiller legs clockwise to raise the wine chiller, counterclockwise to lower it.

Door Lock (available on some Models)

The key is located inside the plastic bag containing the Owner's Manual. Insert the key in the lock and turn it counterclockwise to unlock the door. To lock the door do the reverse operation. Remove the key and place in a secure location.

Interior Light (available on some Models)

You can turn the light ON or OFF by pushing the light switch located on the right side of the control panel housing. If the interior light is left on, the temperature will be higher.

Loading the Wine

As with any refrigeration product, there is a slight temperature variance at different locations within the cabinet. In this wine chiller, the lower shelves provide a slightly cooler temperature than the upper shelves.

When storing both red and white wines, it is best to store the white wine on the lower shelves where the temperature is slightly cooler.

4