About the control and settings. |
|
|
|
|
|
| www.GEAppliances.ca |
MAX |
|
|
| 6 |
|
|
|
|
| 7 |
| 5 |
|
| TEMPERATURE |
|
|
|
|
|
| ||
MED |
|
|
|
|
|
| |
0 |
|
|
|
| 4 | CONTROL | |
|
|
|
|
|
|
| |
0 |
|
| 1 |
| 3 |
| 7 IS COLDEST 15W MAX |
|
|
|
|
| |||
MIN |
|
|
| 2 |
|
|
|
|
|
|
|
|
|
| |
Control Settings (Mechanical Control) |
|
|
|
|
|
|
|
To start the Wine Chiller turn the Temperature Control Knob located inside or on the exterior rear wall of the cabinet to the position corresponding to the desired setting on the graduated dial. The temperature range of the Chiller can be controlled between 50 °F (10 °C) and 59 °F (15 °C). (Temperatures may fluctuate by 5 °F [3 °C].)
Red White | C |
|
Red |
| 15W |
| MAX | |
|
| |
White |
| SET |
|
| |
(Available on some models) | (Available on some models) | |
|
|
Control Settings (Electronic Temperature Control)
PRESET WINE ZONES:Press the [RED] or [WHITE] pads to choose preset storage conditions for Red or White Wine. The programmed Temperature for red or white wine will be displayed for a few seconds (the actual temperature of the Chiller is displayed in normal operation).
TEMPERATURE CONTROL:The temperature of the Chiller is controlled by the temperature up and temperature down pads. The temperature can be set anywhere between 40°F to 65°F (4°C to 18°C) as follows.
(1) Press the [SET] pad until you hear a "beep" sound (approximately fifteen seconds).
(2) Press the pads to increase or decrease the desired temperature in increments of one degree.
(3)Press [SET] to confirm your choice - if confirmation is not made within ten seconds the unit will go back to the previous setting.
NOTES:
The cabinet temperature in degrees Celsius is displayed during Normal Operation. The status of the refrigeration cycle is indicated by the indicator light as follows:
(1)Flashes before the compressor starts,
(2)Remains ON during the refrigeration cycle and
(3)Remains OFF during the idle cycle.
FACTORY SETTINGS:To return the Controller back to Factory Setting simply:
Press and hold the [White] pad, within one second press the [Red] pad and continue holding both for approximately ten seconds - until a "beep" sound is heard signalling that the Controller is back to the original Factory Setting.
Note: This can be used if needed to troubleshoot the Wine Chiller.
Safety Instructions
Instructions | Installation |
|
|
Operating Instructions |
Care and Cleaning
Troubleshooting Tips |
Consumer
After plugging in the wine chiller and making your selection ( RED or WHITE WINE ), allow the wine chiller to reach the set temperature before loading your wine. This may take up to 12 hours to completely stabilize.
After loading the wine, you may notice a rise in the temperature. Allow adequate time for the temperature to return back to the set temperature. This may take up to 12 hours to completely stabilize.
5