Modification 3&4 | Modification 1&2 |
Cut here (c)
Cut here (c) | Add Jumper (d) |
Add Jumper (d) | Cut here (c) |
TECH
STUFF
POD
b b
a
MAIN CHASSIS
POD
MAIN CHASSIS
POD
This modification moves the
Channel Access points to
1.Follow steps 1 through 5 at the bottom of page 31.
2.Cut traces as shown at points (a), (b) and (c) in the lower drawing .
3.Add jumpers (d) & (e). Don’t smash the jumper down onto the circuit board. Let it “arch” above.
4.Add a
5.Follow steps 9 to 11 at the bottom of page 31.
Any internal modification of the
*Note: Traces on different channels may vary slightly from the drawing. (Engineering sez channel strips are like snowflakes).
34