CHANGING THE POD TO RACK MOUNT POSITION
It only takes about five minutes and a
1.Remove all cords and cables from the mixer, including a lamp if you’ve plugged one in.
2.Place the mixer gently face down on a clean, soft surface such as a blanket or very large dog.
3.Remove the four #6 screws securing the small slotted black plate on the bottom of the main part of the mixer. Keep track of which screws go where.
4.Remove the two #8 screws on each side of the mixer which secure the pod. Gently pull the pod away from the main chassis.
5.Lift the pod over the main part of the mixer. Replace the slotted plate but install it turned around 180˚ with the ribbon cables in the slot.
6. Lower the pod back onto the slots.
7.Reinstall two #8 screws on each side to secure the pod. DO NOT press hard while inserting these screws.
8.Install the rack “ears” on the sides of the mixer. DO NOT press hard while inserting these screws.
The BNC lamp socket is no longer accessible in this position.
Remove back plate
Remove screws here on each side.
Replace back plate after rotating 180˚. Thread ribbon cable through slot
Add screws here.
Then add rack rails
JACKS TO TOP?
You can also rotate the pod so that the inputs and outputs are on the same plane as the main
20