PPM1008

Rear Panel Features

2 X 800W PROFESSIONAL POWERED MIXER

 

 

2

4

 

 

 

6

1

3

6

 

 

 

OUTPUT POWER: @ 4 OHMS, 800 WATTS PEAK PER CH

MINIMUM LOAD: 4 OHMS PER CHANNEL

5

1. POWER CONNECTION

This jack accepts the supplied ­3-prong IEC AC power cord.

Before you plug the AC power cord into the

powered mixer, make sure that the voltage of your unit is the same voltage as your local AC

mains supply. Use only the power cord supplied. Also, disconnecting the plug’s ground pin is dangerous. Please don’t do it.

2. POWER SWITCH

Press the top of this rocker switch inwards to turn on the mixer. The front panel power LED [35] will glow with happiness, or at least it will if you have the mixer plugged into a suitable live AC mains supply.

Press the bottom of this switch to turn off the mixer, whenever you feel that this would be a safe thing to do.

3. SPEAKER-LEVEL OUTPUTS

These output connections provide speaker-level output power from the internal power amplifiers to your passive speakers. The power output of the PPM1008 is 500 watts rms per channel into 4 ohms.

Only passive loudspeakers should be connected to these speaker-level outputs.

The outputs can be selected with the amp mode switch [4] to be either the stereo main mix, mono main mix/monitor 1, or monitor 1/monitor 2.

Two common types of connector are provided for your convenience: Speakons and 1/4" TS.

1–

1+

COLD

1–

Half-way through a heavy metal guitar solo might not be

HOT 2+

1+

such a good time.

As a general guide, you should turn on your mixer first, before any external power amplifiers or powered speakers, and turn it off last. This will reduce the possibilities of any turn- on, or turn-off thumps in your speakers.

2–

•Speakon outputs are wired Pin 1+ positive

(hot) and Pin 1– negative (cold).

Mono Speakon Connection

10

PPM1008