Magic Chef MCKC490S instruction manual CO2 GAS CAN BE DANGEROUS, Electrical Connection

electrical consumption. Extreme cold ambient temperatures may also cause the Beer Dispenser not to perform properly. This unit is not designed for outside installation (ie garages, porches etc.)

•Avoid locating the Beer Dispenser in moist areas.

•Plug the Beer Dispenser into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized service center.

•After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing any contents in the Beer Dispenser compartment.

￿Electrical Connection

￿Warning￿

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized service center.

This Beer Dispenser should be properly grounded for your safety. The power cord of this Beer Dispenser is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord supplied.

Use of extension cords is not recommended.

This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground. The cord should be secured behind the Beer Dispenser and not left exposed or dangling to prevent accidental injury.

Never unplug the Beer Dispenser by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.

Warning

CO2 GAS CAN BE DANGEROUS

WARNING: CO2 cylinders contain high-pressure compressed gas which can be hazardous if not handled properly. Make sure you READ and UNDERSTAND the following procedures for CO2 cylinders BEFORE INSTALLATION.

1.ALWAYS connect the CO2 cylinder to a regulator. Failure to do so could result in explosion with possible injury when the cylinder valve is opened.

2.NEVER connect the CO2 cylinder directly to the product container.

3.ALWAYS follow correct procedures when cylinders are changed.

4.ALWAYS secure the cylinder in an upright position.

5.NEVER drop or throw a CO2 cylinder.

6.ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in a cool place (preferably 70°F). Securely fasten with a chain in an upright position when storing.

7.ALWAYS ventilate and leave the area immediately if CO2 leakage has occurred.

8.ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5) years, do not use, return cylinder to gas supplier.

9.NEVER connect a product container unless there are two (2) safety’s in the pressure system:

a.One at or on the CO2 regulator

b.One at or on the product coupler or in the pressure gas line.

5