M5100CDUMFinal 2/1/05 4:58 PM Page 13
Installation
Sheet Metal
Screw
Nut
Washer
Metal Strap
Mounting Surface
Trouble Shooting
Before going through the trouble shooting table below, check the wiring connection. If the problem persist, consult your nearest service dealer.
SYMPTOM | CAUSE | SOLUTION |
|
|
|
No power | The ACC Power Supply is not | Both the red and yellow |
| connected. | wires require power from the |
|
| power source. |
| The fuse is blown. | Replace the fuse. |
|
|
|
Disc cannot be loaded, | Presence of disc inside the player. | Remove the disc in the player, and |
played or ejected |
| replace it with another disc. |
|
|
|
| Disc was inserted upside down. | Insert the compact disc with the |
|
| label facing up. |
| Compact disc is extremely dirty or | Clean the disc or try playing a |
| disc is defective. | another disc. |
| Temperature inside the unit is | Allow the unit to cool off, |
| too high. | then try again. |
|
|
|
| Condensation. | Leave the player off for an hour, then |
|
| try playing it again. |
|
|
|
No sound | Volume is set at the minimum level. | Adjust volume to the desired level. |
|
|
|
| Speaker wiring is not properly connected. | Check the wiring connection. |
Sound skips | The installation angle is more | Adjust the installation angle to less |
| than 30 degrees. | than 30 degrees. |
|
|
|
| Compact disc is extremely dirty or | Clean the disc or try playing a |
| disc is defective. | another disc. |
The operation keys | The | Press the RESET button. |
do not work | is not operating properly | Front panel is not properly fixed |
| due to noise. | into its place. |
The radio does not work | The antenna cable is not connected. | Insert the antenna cable firmly. |
|
|
|
The radio station automatic | The signals are too weak. | Select a station manually. |
does not work |
|
|
|
|
|
|
|
|
13
