Model:
Installation and User Guide
For use in vehicles with 12V negative ground electrical systems only. Use of the
| Specifications |
|
| Safety Features | |
• | Input Voltage Range: . . . | . . . . . . . . . . . . . . . . . . | • | Auto Operating Fan | |
• | Input Full Load Current: | . . . . . . . . . . . . . . . . . . | . . . . . . 30A | • | Overload Protection |
• | Standby Input Current: | . . . <0.32A | • | Output Short Circuit Protection | |
• | Output Voltage (AC): . . . | . . . . . . . . . . . . . . . . . . | 110V ± 5% | • | Reverse Polarity Battery Protection |
• Continuous Output Power: | . . . . 300W |
|
| ||
• Dimension | (L) 155mm (W) 73mm (H) 73mm |
|
| ||
• | Weight | 2lbs.(900g) |
|
| |
• Replacement Fuse | . . . . . . . . . . . . . . . . . . | . . . . . . 35A |
|
| |
Trouble Shooting
When the Power Inverter Does Not Appear to be Functioning Properly, Check the Following Trouble Shooting Procedures.
1)Poor Contact: clean contact parts thoroughly.
2)Receptacle Has No Power Output: (a) Check fuse, replace damaged fuse with same amperage. (b) Check receptacle wiring, repair if necessary.
3)Output Short, Heat Overload: Under heavy loads, the AC output will decrease. This is to protect the Unit from overheating, (a) turn off the unit until it cools down
(b)Disconnect some of the appliances. (c) Check the power consumption of your AC appliance, make sure it is below 300W.
| Warning Signals |
|
|
|
• | Low Battery | . . BI | BI | BI |
• | Over Heating | . BI | BI BI | BI |
• | Over Load | . BI BI BI BI BI | ||
• | Output Short | BIBIBIBIBIBIBI | ||
Connection
Caution! DO NOT reverse power input connection, it can cause severe damage to the power unit.
Mounting
Acceptable mounting positions
Note: be sure to leave at least 1" around the unit for proper ventilation.
Mount
WARNING! Do Not Reverse Polarity
Red Wire: Connect to Switched +12V
Black Wire: Connect to Ground
Floor Mount
1111 West Victoria Street | ||
Rev. A | ||
Compton, CA 90220 | ||
© 2002 Copyright Magnadyne Corporation | ||
|
