Magnat Audio 400 / 1000 Bass-Boost, Outputs For Connecting Additional Amplifiers, Stereo Mode

GB

5.4 BASS-BOOST

The bass-boost function (4) is used to increase or equalize the lower bass frequencies.

5.5 OUTPUTS FOR CONNECTING ADDITIONAL AMPLIFIERS

The input signal of the LINE INPUT connections L and R (2) is forwarded directly to the LINE OUT (1) L and R jacks. The LINE OUT connections allow the use of additional amplifiers without requiring additional T-plugs and cables.

FIG. 1 POWER SUPPLY / REMOTE SWITCH-ON CONNECTION

(1)GND terminal for the ground, to the battery's minus pole

(2)REM terminal for remote switch-on

(3)Terminal for + 12 V battery voltage

(4)Battery

(5)Cable fuse

(6)To your car radio's automatic aerial connection

If your car is not equipped with an automatic aerial connection, connect this cable's plus pole (+) to the ignition lock. An on/off switch should be inserted in this case. Make sure that this switch is switched off if the amplifier is not used.

FIG. 2 STEREO MODE

Connect and set the amplifier as shown in Fig. 2 if it is to be controlled with two output channels and to use two loudspeakers. The high-pass filter must also be activated if the amplifier is also used for satellite loudspeakers. See Chapter 5.3.

(1)To the car radio, left output

(2)To the car radio, right output

(3)Loudspeaker left

(4)Loudspeaker right

FIG. 3 BRIDGE MODE WITH STEREO CAR RADIO

If the amplifier has to generate more power to operate a subwoofer, connect and set it as shown in Fig. 3. The use of the low-pass filter is described in Chapter 5.2.

(1)To the car radio, left output

(2)To the car radio, right output

(3)Subwoofer

14