Basic Cable TV Connection
The cable TV signal into your home may be a single cable (75ohm) or may include
acable Box. In either case, the connection to t he TV i s ea sy.
If your Cable TV signal comes directly via a 75 ohm coaxial cable, use the foll- owing steps:
Connect the Cable TV signal to the
75OHM ANTENNA INPUT jack on the rear of the TV. Screw it down finger tight.
Cable TV company
Plug the TV s power cord into a power outlet and turn on the TV. Set
TV/CATV to CATV as detailed in page 11.
Refer to AUTO SEARCH to set up your available channels. Details are on page 12.
75OHM
ANTENNA
INPUT
If you have a Cable Box, use the follow- ing steps.
Connect the Cable TV signal to the IN jack on the Cable Box.
Connect the separate coaxial cable to the OUT jack on the Cable Box and to the 75 OHM ANTENNA INPUT jack on the rear of the TV.
Plug the TV s power cord into a power outlet and turn on the TV. Set TV/CATV
to CATV as detailed in page 11.
Set the TV to channel 3 or 4 (the same
as the Channel3/4 switch on your Cable Box if applicable). Change channels at
the Cable Box.
Cable TV company
Cable Box
75OHM
ANTENNA
INPUT
Helpful Hints
An RF coaxial cable (to con- nect the Cable Box to the TV) may be supplied by the Cable TV company. It is not supplied with the TV but it is available from Magnavox or electronics retailers.
You can connect a Satellite Receiver the same way you would connect a Cable Box.
Your Cable Box may have separate Audio and Video Out jacks instead. If so, use audio and video cables to connect the AUDIO /VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO IN2 jacks on the rear of the TV.
Press the TV/AV on the remote control to set the TV to the AV2 channel. Change channel at the Cable Box.
5
