EnglishFrançaiseEspañol
5
Note: The first time (and only the first time) you turn on your set you see an installation introduction screen. The Installation procedure consists of a
series of screens that guide you through the process.
& After an introduction screen, you are asked to select a language of the TV’s on-screen-menus. (The text of the header and the info on screen
continuously change language.)
é Press the cursor up/down to highlight your language.
“ Press the OK button.
‘ Follow the on-screen instructions to proceed.
First time installation
Part 1: TV installation
(Please skip this section if you have no cable connected to the Antenna input of the TV.)

Note - The TV will take approximately 10-15 seconds to start up.

& Select the desired Language and press the green button "Next".
é Select Cable or Antenna in the Installation mode and press the green button "Next".
“ Auto Installation may take 20 to 40 minutes depending on the number of channels that are transmitted by the cable provider or
broadcaster.
‘ When the TV is not receiving any signal from the antenna/cable, the message CHANNEL NOT AVAILABLE will appear on the TV
screen. When no transmission is received from the broadcaster, a BLANK SCREEN will appear on the TV screen.
Note - The TV will go on to standby after 10 minutes. Press the POWER button on the remote control to on the TV.
( You will not be able to receive pay channels when using direct antenna/cable connection to the television.
§ When the Set-top box is connected to the television using coaxial cable, it is necessary to auto-program the television for the single channel
(3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program.
Refer to the manual for more details.
Note - The newly installed channels maybe sorted in a different sequence on this TV. Please key using the CH +/- buttons to get to know the
new channel. Also you can use the OK key to see the list of channels.
è When the Set-top box is connected to the television using one of the AV connections (AV 1/ AV 2/ HDMI 1/ HDMI 2), select that input
source (using the AV button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to
view the program.