Magnavox MC132DMG, MC192DMG Turning On the TV/VCR, Press the Power button. The TV/VCR will

MC132DMG/MC192DMG 3/22/02 1:21 PM Page 8

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure batteries are in the remote control and you have connected the TV/VCR correctly.

The instructions on this page work only when you turn on the TV/VCR for the first time.

Press the POWER button. The TV/VCR will
1 come on and the screen shown below will appear.
SELECT LANGUAGE
> ENGLISH	ON
ESPAÑOL

SELECT KL OR

PRESS MENU TO CONTINUE

2 Press the PLAY/K button or the STOP/L but- ton to select English or Spanish on-screen dis- plays and menus.

3 Press the MENU button. The screen shown below will appear.

CONNECT ANTENNA OR CABLE

TO TVCR

THEN PRESS B

TO END PRESS EXIT

4 Press the F.FWD/B button to begin automatic channel setup. The TV/VCR will memorize all avail- able channels. When channels are set, CHANNELS ARE SET will appear on the screen briefly. Then the TV/VCR will go to the lowest available channel.

If you try to set up channels when there is no anten- na or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on the screen. Connect an antenna or cable to the ANT(enna) jack on the TV/VCR, then press the F.FWD/B button again. You may need to follow the steps on page 10 instead.

5 Use the CH(annel) o/p buttons or the

Number buttons on the remote control to select a TV/VCR channel. Use the VOL(ume) o/p buttons to adjust the sound.

When you scan channels with the CH(annel) o/p buttons, only the memorized channels will be avail- able. Use the Number buttons to select non-memo- rized channels.

1 2,4

POWERSLEEP/WAKE UP

3		PLAY
	REW		F.FWD
		STOP
	MENU	STATUS/EXIT		CLEAR
	1	2	3		5
	4	5	6	CH.
	7	8	9
		0	ALT.CH	VOL.
	SPEED	MEMORY	PAUSE/STILL
	REC/OTR	TRACKING		MUTE

Helpful Hints

•If you do not see any on-screen displays when you turn on the TV/VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps on pages nine-10 to select a language and set up channels.

•To skip step 2, press the MENU button. All on-screen displays will be in English. To skip step 4, press the STATUS/EXIT button.

Automatic Channel Setup will not occur, and CHANNELS NOT SET will appear on the screen briefly.

•You cannot set up channels if you are using a Cable Box.

•Line Input mode is channel 00. When you select channel 00, A/V IN will appear on the screen briefly. Press the CH(annel) o/p buttons or the Number buttons to

select another channel.