GENERAL INFORMATION / CD PLAY | CD PLAY / FEATURES |
In-car use (connections supplied or optionally available)
Only use a 4.5 V DC car voltage converter (positive pole to the center pin) and cassette car adapter. Any other converter may damage the set.
1Put the set on a horizontal,
in a safe place, where the set is neither a dan- ger nor an
obstacle to the driver and the passengers.
2 Plug the voltage converter into the cigarette lighter jack (only for 12 V car battery, negative grounding), then connect the wired end with 4.5V DC input jack on the set.
3 If necessary, clean the cigarette lighter jack to obtain a good electrical contact.
4Turn down the volume and connect the cassette adapter plug to LINE OUT/p on the set.
5Carefully insert the cassette adapter into the car radio’s cassette compartment.
6Make sure the cord does not hinder your driving.
7Decrease the volume on the set, if necessary. Start playback on the set and adjust the sound with the car radio controls.
•Always remove the voltage converter from the cigarette lighter jack- when the set is not in use.
Note: If your car radio has a LINE IN jack, it is better to use it for the
car radio connection instead of the cassette.adapter. Connect the signal lead to this LINE IN jack and to LINE OUT/p on the set.
Playback information
•If a
•When playing a
•Playback will stop if you open the CD lid.
•While the CD is read, 01
Volume and bass
Volume adjustment
• Adjust the volume by using VOL E.
Bass adjustment
• Press DBB to switch the bass enhancement on or off
yDBB appears if the bass enhancement is activated.
