Magnavox MZ7 Tape Playback, Rewind/Fast Forward, 3a For Tape Deck 2 only, 3b For Tape Deck 2 only

(only on

Tape Playback

1Press TAPE to select TAPE mode.

ª “TAPE 1” or “TAPE 2” will be

displayed.

•Press TAPE again to select either tape deck 1 or tape deck 2.

2Load the tape into the desired tape deck.

3Press PLAYƒto start playback.

3a (For Tape Deck 2 only)

Press A•B (SIDE) to switch playback between side A and B.

ªThe BACK or FRONT flag appears on the display, depending on the side selected.

3b (For Tape Deck 2 only)

Press A. REV to select the different type of playback mode (see auto reverse playback).

4Press STOP to end playback.

Note:

–To change side before playback begins, use the SIDE button on the remote control.

Auto Reverse Playback tape deck 2)

•Press A. REV to select the different playback modes.

Œ....... to record or playback on one side of the tape. The tape stops

at the end of one side.

•...... to record or playback on both sides of the tape. The tape then

stops.

º.... to playback continuously on both sides of the tape up to a maximum of 10 times per side unless you press STOP.

Rewind/Fast Forward

When playback is stopped

1You can rewind or fast forward the tape by pressing S or T (or ˆ/

‡on the remote control) respectively.

ª"TA 1 XXX" or "TA 2 XXX" will be displayed depending on which button is pressed.

ªThe tape will stop automatically at the end of the rewinding or fast forwarding.

2Press STOP to stop rewinding or fast forwarding.

During playback

• Press and hold S or T (or ˆ

/‡on the remote control) until the desired passage is located.

ª During searching, the sound is reduced to a low volume.

ª When you release S or T, the tape continues playing.

Notes:

–"XXX" denotes the tape counter number. It will automatically set to zero after detecting end of tape or changing tape play direction on TAPE 2. To reset the tape counter number to zero during playback, press the DIM button for more than 2 seconds.

–During rewinding or fast forwarding of a tape, it is also possible to select another source (e.g. 3 CDC, TUNER or CDR/ AUX).

–Before use, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism.

–C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system.

–Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a

transformer, TV, or speaker).

.

TAPE

English

21