CONTENTS |
|
General Information | 9 |
Safety Information | 9 |
Preparation | 10 - 11 |
Controls | 12 - 14 |
Operating The System | 14 - 16 |
CD | 16 - 18 |
Tuner | 19 - 20 |
Tape | 20 - 21 |
CDR/AUX | 22 |
Recording | 22 - 23 |
Clock | 24 |
Timer | 24 - 25 |
Sleep | 25 |
Maintenance | 25 |
Specifications | 26 |
Troubleshooting | 27 |
GENERAL INFORMATION
General Information
•The typeplate (which contains the serial number) is located at the rear of the system.
•Recording is permissible if copyright or other rights of third parties are not infringed.
•This device complies with part 15 of the Federal Communications Commission (FCC) rules. Operation is subjected to the following two conditions:
–This device may not cause harmful interference, and
–This device must accept any interference received, including interference that may cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Accessories (Supplied)
–Remote control
–Batteries (two AA size) for remote control
–AM loop antenna
–FM wire antenna
–AC power cord
Safety Information
•Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. The typeplate is located at the rear of your system.
•When the system is switched on, do not move it around.
•Place the system on a solid base (e.g. a cabinet).
•Place the system in a location with adequate ventilation to prevent internal heat
•The system incorporates a
•Do not expose the system to excessive moisture, rain, sand or heat sources.
•Under no circumstances should you repair the system yourself, as this will invalidate the warranty!
SAFETY INFORMATION
•If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.
•Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.
•To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
English
9
