Operating Instructions, Louvre Removal | Majestic Appliances LDVR1

LDVR Series Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with frame window) is available through your CFM Corporation dealer and should only be installed by a licensed qualiﬁed service person.

��

Louvre Removal

6.Tilt the window frame assembly out slightly at the bottom, lift the window frame assembly up and away from the ﬁreplace.

7.To replace the window frame assembly reverse the procedure.

Lower Clamps

		Window
		Frame
	Window	Assembly
	Window
	Frame	Pull Clamp
	Assembly	Pull Clamp
	Assembly	Hook
	Push	Hook
	Clamp
	Handle	FP1228
		FP1228

Fig. 40 Window frame assembly removal.

Glass Cleaning

The top louvre panel is removed by lifting the panel vertically and pulling it away from the appliance. (Fig. 39) The lower access door is hinged along the bottom edge and is folded down to allow access.

Louvre

Glass Panel

FP1227

Fig. 39 Remove top louvre assembly.

It is necessary to periodically clean glass. During start- up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface.

Also initial paint curing may deposit a slight ﬁlm on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas ﬁreplace glass cleaner) within the ﬁrst few weeks of operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Window Frame Assembly Removal

1.Turn the ﬁreplace OFF (including the pilot)

2.If the unit has been operating allow time for the components to cool.

3.Remove the top louvre assembly.

4.Open the lower louvre panel.

5.Release the two clamps securing the lower edge of the window frame assembly by pulling down on the handles. (Fig. 40)

Clean glass after ﬁrst two weeks of operation.

Do not clean glass when hot. Do not use abrasive cleaners. Do not strike or slam the glass.

10007317

Majestic Appliances LDVR1 Operating Instructions, Glass Information, Louvre Removal

Models: LDVR1