Majestic Appliances LDVR1 Flame Characteristics, Flame & Temperature Adjustment

LDVR Series Direct Vent Gas Fireplace

43LDVR

1. Place rear log (BD15) on rear bracket		Top Center
(ensure log is centered and seated	Rear	(BBD18)
properly to the log support).
	(BD15)
2. Place front left log (BD16). Use log’s		Front Right
bottom notch to locate it onto the front		(BD17)
support and just rest on top of the	Front
burner housing tile.
	Left
3. Place front right log (BD17). Use log’s	(BD16)
bottom notch to locate it onto the front
support and just rest on top of the
burner housing.

4. Place ember material on top of burner.

5. Scatter the ember material over the

tiles on the front area of the burner

housing. (Fig. 44) Do not pack the

Lava

ember material. Separate it when

Rock

unpacked and keep it in

a fluffy and

Lava Rock

Ember Material

loose condition for a more realistic

ember effect.

Front Center

6. Place front center log (B138) on top of

(B138)

LG434

the two small shelves at the front log

Fig. 44

Correct log placement for 43LDVR.

support, and between the left and right

Do not place any of the lava rock material

logs.

on the burner housing assembly.

7. Place top center log (BD18) on top of the rear log

using the hole locator under the log and on top of

Flame Characteristics

front right log.

8. Scatter lava rock material round the firebox base.

It is important to periodically perform a visual check

of the pilot and burner flames. Compare them to the

Flame & Temperature Adjustment

illustrations. (Figs. 47-48)

If the flame patterns appear abnormal contact a

RN/RP & EN/EP Models

qualified service provider for service and adjustment.

For units equipped with “HI/LO” valves the flame

adjustment is accomplished by rotating the “HI/LO”

adjustment knob located near the center of the gas

control valve. (Figs. 45 & 46)

SIT RN/RP

Turn

Honeywell Valve

counterclockwise

��

��

Turn clockwise

to decrease

to increase

flame height

flame height

Fig. 45 Flame adjustment knob for Honeywell valve.

Turn	SIT 820 Valve
		Turn clockwise	SIT EN/EP
counterclockwise
	H
	I
to increase	L	to decrease
	O	flame height
flame height
			FP1541
Fig. 46 Flame adjustment knob for SIT valve.			Fig. 47 Correct pilot flame appearance.

26 10007317